Setting Up Your 3M Multi-Touch Chassis Display; System Requirements; Unpacking Your Touch Display - 3M C3266PW User Manual

8
Chapter 1
Setting Up Your 3M Multi-Touch Chassis
Display
To setup your display you need to complete the following tasks:
Unpack the components
Connect the video cable, touch display cables, and power cable
Power on the display and test your setup
If your operating system does not support native touch, install 3M MicroTouch™ MT7 Software.

System Requirements

This display requires a personal computer (PC).
Your PC must have an available USB port or RS-232 serial communication port (C3266PW only).
Connect the touch sensor cable to the communications port.
Your PC must have a video card and video driver already installed for the display.
Note: Before setting up your 3M Multi-Touch Chassis Display, refer to the "Important
Safety Information" section at the beginning of this document.

Unpacking Your Touch Display

Carefully unpack the carton and inspect the contents. Your 3M Multi-Touch Chassis
Display includes the following:
USB Cable
VGA Cable
3M Touch Systems, Inc. Proprietary Information
3M™ Multi-Touch Chassis Display User Guide
9-pin RS-232 serial cable
(Qty 2 for C3266PW only)
DVI Cable