Fcc Warning; Ce Conformity For Europe - 3M C3266PW User Manual

28
Your 3M Multi-Touch Chassis Display may comply with additional regulatory standards.
Please contact 3M Touch Systems Customer Service or your Field Application Engineer
if you have questions pertaining to a certification not listed above.
This equipment has been tested and found to comply within limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in residential installations. This
equipment generates, uses and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television
equipment reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Move the equipment away from the receiver.
 Consult the dealer or an experienced radio/television technician for additional
suggestions.
Note: You are cautioned that any change or modification to the equipment not expressly
approved by the party responsible for compliance could void your warranty.
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
This device complies with Part 15 of the FCC rules: Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.

FCC Warning

To assure continued FCC compliance, the user must use the supplied grounded power
supply cord and the provided shielded video interface cable with bonded ferrite cores.
Also, any unauthorized changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this device.
3M Touch Systems is not responsible for any radio or television interference caused by
using other than recommended cables and connectors or by unauthorized changes or
modifications to this equipment.

CE Conformity for Europe

The device complies with the requirements of the EU RoHS Directive 2011/65/EU, the
EMC Directive 2014/30/EU with regard to "Electromagnetic compatibility" and EU Low
Voltage Directive 2014/35/EU with regard to "Safety".
3M Touch Systems, Inc. Proprietary Information
3M™ Multi-Touch Chassis Display User Guide