Configuring Wi-Fi Settings - HIKVISION DS-6900UDI User Manual

 The port aggregation is not supported by DS-6901UDI.
 The switch connected to DS-6900UDI must be configured with the port aggregation as
well.
 Two adjacent network interfaces cannot be selected to form a link. For example, you can
select Network Interface 1 and Network Interface 3, or Network Interface 2 and Network
Interface 4.
 The network interface 1 corresponds to the GE1 interface, network interface 2 to G1,
network interface 3 to GE2, and network interface 3 to G2 on the rear panel.
 The G1 and G2 can be used as 2G switch when the network interface 2 and network
interface 4 are configured in port aggregation.
5.6.2

Configuring Wi-Fi Settings

Purpose
The Wi-Fi can be used as the supplement of the wired network. You can get stream and decode
the video on the video wall when Wi-Fi is enabled if no wired network can be accessed.
Before you start
The Wi-Fi is disabled by default. You must enable DHCP first on the WLAN Settings interface.
Step 1 On the Remote Configuration interface, click Network > Wi-Fi and click Configuring the Wi-
Fi Settings tab to enter the Wi-Fi Settings interface.
HD Video and Audio Decoder User Manual
Figure 5-60 Wi-Fi Settings
81
DS-6900UDI Decoder User Manual