Disassembly The Primary Shaft And Pulley - Technogym SYNCHRO Excite + Service And Maintenance Manual

7.11. DISASSEMBLY THE PRIMARY SHAFT AND PULLEY

Figure 7.11-1
Figure 7.11-2
Figure 7.11-3
Page 7.36
SYNCHRO Excite +: Service & maintenance manual - rev. 7.1
Carry out the
paragraph: 7.7.1. "Rear guard".
For remove the pulley on both levers:
1. Back off the screw (a), with a 10mm
hexagonal wrench, looking it on the opposite
side.
ATTENTION:
lock down the screws (a) using a
torque wrench setting of 9Nm.
2. If necessary replace the bearing (b) removing
the internal snap-ring (c).
3. Back off the screw (d) that looks the bars (e)
with a small extractor, as shown in the figure
at the side.
operations described
During reassembly,
Continued in following page...
in