Brake Winding Positioning - Technogym SYNCHRO Excite + Service And Maintenance Manual

SYNCHRO Excite +: Service & maintenance manual - rev. 7.1

8.3. BRAKE WINDING POSITIONING

Figure 8.3-1
Carry out the operations
paragraph: 7.7.1. "Rear guard".
1. Loosen the 2 screws (a) with a 17mm
wrench.
2. Move the brake winding plate support (b),
horizontally as indicated by arrows, so that
the copper disk is centred on the brake
winding, using a 1mm thickness gauge.
3. Tighten again the screws.
ATTENTION: To correctly adjust the
brake position, test the machine at
high levels and check that the flywheel
it is not touching on it.
WARNING:
comparator to check the copper disk
flatness, the permissible margin is ±
0.15 mm.
described in
Use a flatness
Page 8.3