Ice RS26 Operator's & Parts Manual page 11

OPERATOR MANUAL
4. Remove the vacuum fan inlet filter and rinse it
out with clean water.
5. Clean machine with an approved cleaner and a
damp towel.
6. Recharge the batteries.
7. Check the condition of the squeegee blade
wiping edge, rotate blade if worn.
montHly maIntenance
1. Clean the battery tops to prevent corrosion.
2. Check for loose battery cable connections.
3. Inspect and clean the recovery tank cover seal.
Replace it if damaged.
4. Lubricate all grease points and pivot points with
silicon spray and approved grease.
5. Check the machine for loose nuts and bolts.
6. Check the machine for leaks.
motoR maIntenance
1. Contact your local Distributor for any motor
maintenance.
2. Motor should have the brushes checked every
250 hours. Brushes should be replaced when
they are worn to a length of 10 mm or less.
BatteRy maIntenance
WaRnInG: Batteries emit hydrogen gas
and an explosion o fire can result. Keep sparks
and fire away from batteries at all times.
WARNING: Whenever servicing batteries,
be sure to wear protective gloves. Avoid
contact with battery acid at all times.
The machine is equipped with a LED display
screen (see Machine components, item # 31), the
LED screen will display the operating hours (see
Machine components, item # 35) and the battery
level status (see Machine components, item # 30).
When the machine detects a fault, there will be a
Fault code (see Machine components, item #33)
& Fault message (see Machine components, item
#34) display on the LED screen, and the Fault
indicator (see Machine components, item #32) will
flash continuously, accompany an audible alarm
Occasionally.
11
NOTE: For the best machine performance, keep
batteries charged at all times. Do not let them
sit in a discharged condition.
1. Always follow the battery charging directions as
2. Keep battery tops and terminals free from
3. Use a wire brush with the baking soda solution
4. Check battery connections for wear and loose
1. Always store the machine indoors.
2. Always store the machine in a dry area.
3. Always store the machine in its upright position.
4. Always store the machine with the pad driver/
5. Always store the machine with the squeegee
6. If storing in an area which may reach freezing
7. Drain the recovery tank.
8. Drain the solution tank of all fluid.
FAULT CODE & SOLUTION
Once fault occuring, please DO NOT continue
operate the machine unless the fault are eliminated.
Turn off the machine, then to solve the fault, the
fault code & message will be eliminated when
machine restart.
If the fault is occurred frequently, or the fault can't
be eliminated, please contact ICE service center.
Please refer to the below table to determine the
fault cause and the solution.
outlined in the BATTERY CHARGING section of
this manual.
corrosion. A strong solution of baking soda
and water is the best way to keep the batteries
corrosion free. DO NOT ALLOW THE BAKING
SODA / WATER SOLUTION TO ENTER THE
BATTERY CELLS.
to properly clean the battery posts and
connections.
terminals. replace if necessary.
macHIne StoRaGe
brush raised off the floor.
assembly raised off the floor.
temperatures, be sure to drain all fluids from the
machine prior to storage. Any damage caused
by freezing temperatures will not be covered by
the warranty.
ICE RS26 / RS28 / RS32