Using Auto Drawer Switching To Its Fullest - Canon C850 Practical Manual

Using Auto Drawer Switching to Its Fullest

Auto Drawer Switching is a function that automatically feeds paper from a different paper drawer when the specified
paper drawer runs out of paper� You can prevent the machine from running out of paper by using this function� This
section explains how to use Auto Drawer Switching for large print job that is printed from a computer as an example�
IMPORTANT
When you refill the paper drawer, be careful not to open the paper drawer that the machine is currently using� Doing
so may cause a paper jam�
Example: To print 10,000 pages in a row using Plain 1 (80 g/m
The Multi-drawer Paper Deck-B1 has three paper sources, the upper, middle, and lower drawers, and each can
stack up to 2,000 sheets of paper (80 g/m
as the paper runs out, without stopping printing� If you keep refilling the paper drawers so they do not run out,
you can print 10,000 sheets continuously� The paper source changes four times to complete this print job�
Specifying the Settings on the Machine
▀
After you load 2,000 sheets of paper into each of the upper, middle, and lower drawers on the Multi-drawer Paper
Deck-B1, specify the following settings�
1
→ [Function Settings] → [Common] → [Paper Feed Settings] → [Paper Drawer Auto
Press
Selection On/Off ]�
120 120
imagePRESS C850/C750/C650/C65
) using the Multi-drawer Paper Deck-B1
2
)� With Auto Drawer Switching, you can load paper into the drawers
2