Suzuki GSF600Y 2000 Service Manual page 75

• Install the dowel pin, a new gasket and the starter clutch cover,
and tighten the cover bolts securely.
NOTE:
Install the gasket washer to the starter clutch cover bolt A as
shown.
$
Use a new gasket washer to prevent oil leakage.
• Install the oil pressure switch, apply the recommended bond to
its thread and tighten it to the specified torque.
* 99000-31140: SUZUKI BOND "1207B"
" Oil pressure switch: 14 N . m (1.4 kgf . m, 10.0 lb-ft)
• Install the signal generator stator (along with the pickup coil)
1.
• Be sure to fit the slot B on the back surface of the signal gen-
erator rotor over the locating pin 2 on the end of crankshaft.
NOTE:
The recommended bond should be applied to the groove of the
signal generator lead wire grommet C .
* 99000-31140: SUZUKI BOND "1207B"
• Hold the nut and tighten the signal generator rotor bolt to the
specified torque.
( 09900-00410: Hexagon wrench set
" Signal generator rotor bolt: 25 N . m (2.5 kgf . m, 18.0 lb-ft)
• Connect the oil pressure switch lead wire.
• Pass the signal generator lead wire through the upper crank-
case as shown.
ENGINE 3-37