Table of Contents
Advertisement
Configuration (Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
Automatic Programs
To run the FXarray Q5 in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select an automatic program, from P 1–7.
4.
Press <ENTER>.
Auto-Program Speed
To change the auto-program speed on the FXarray Q5, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> or <DOWN> to increase or decrease the program speed, from S 1–100.
3.
Press <ENTER>. The product will return to the last selected mode.
Auto-Program Dimmer
To control the output intensity of the Quad-LEDs while running an auto-program, follow the instructions
below:
1.
Press <MENU> repeatedly until diM shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to increase or decrease the Quad-LED intensity, from L 1–255.
Sound-Active Mode
To run the FXarray Q5 in sound-active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select a sound-active program, from Snd1–5.
4.
Press <ENTER>.
5.
Turn the sensitivity knob up until the product responds to the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
Preset Color Mode
To run the FXarray Q5 on a static color, follow the instructions below:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select a static color, from C 1–22.
4.
Press <ENTER>.
Custom Color Mixing
To custom mix a static color, do the following:
1.
Press <MENU> repeatedly until u-- shows on the display.
2.
Press <ENTER> and one of the following will show on the display:
•
r_ _ _ (red)
•
g_ _ _ (green)
•
b_ _ _ (blue)
•
u_ _ _ (UV)
•
S_ _ _ (SMD strobe speed)
3.
Press <ENTER> to cycle through the settings.
4.
When the desired setting shows on the display, use <UP> or <DOWN> to increase or decrease
the value, from 0–255 for red, green, blue, or UV, or from 0–100 for SMD strobe speed.
5.
Repeat steps 3 and 4 until the product outputs as desired.
Of the four colors (red, green, blue, and UV), only three may be used at one time.
Page 10 of 16
O
PERATION
FXarray Q5 User Manual Rev. 1
Advertisement
Table of Contents
