Table of Contents
Advertisement
5.3
Data Source
Set the data source and the PGN transmitting.
How to select the data source
You can select the data source to display on the screen when data of the same type
is input from multiple sources. For example, you can select the position data from GPS
navigation equipment or the position data from satellite compass when these two po-
sition data are input. The available data are the following:
• Position&SOG/COG
• Depth
• Date/Time
1. Press the MENU key to open the menu.
2. Use the Cursorpad (
3. Use the Cursorpad (
4. Use the Cursorpad (
The list of the data source appears.
5. Use the Cursorpad (
key.
6. Repeat steps 4 and 5 to set the other items if necessary.
7. Press the DISP key to close the menu and display the data screen.
PGN transmitting
Transmit the input data selected as the data source in PGN format.
1. Press the MENU key to open the menu.
2. Use the Cursorpad (
3. Use the Cursorpad (
4. Use the Cursorpad (
5. Use the Cursorpad (
• Heading
• Water Temperature
• Roll/Pitch
or
) to select [I/O Setup] and press the ENT key.
or
) to select [Data Source] and press the ENT key.
or
) to select the item desired and press the ENT key.
or
) to select the data source desired and press the ENT
or
) to select [I/O Setup] and press the ENT key.
or
) to select [Data Source] and press the ENT key.
or
) to select [PGN TX] and press the ENT key.
or
) to select [On] and press the ENT key.
5. INPUT/OUTPUT SETUP
• STW
• Wind
The list of the
data source
(nickname, see
section 5.2)
5-3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
