Furuno RD-33 Operator's Manual page 44

4. ALARMS
2. Use the Cursorpad (
alarms currently violated are displayed.
3. Press the DISP key to close the menu and display the data screen.
Alarm category
The alarm categories displayed on the alarm status are follows:
Alarm category
ARRIVAL ALARM!
ANCHOR WATCH
ALARM!
XTE ALARM!
SOG ALARM!
STW ALARM!
WATER TEMPERATURE
ALARM!
DEPTH ALARM!
4-2
or ) to select [Messages] and press the ENT key. All
Meaning
Your ship enters the alarm zone centering on
the destination waypoint.
Your ship is moving when your ship should be
at rest.
Your ship is off its intended course.
The SOG alarm is generated in one of the fol-
lowing conditions:
• Lower or higher than the SOG setting.
• Inside or outside of the SOG range setting.
• Equal to the SOG setting.
The STW alarm is generated in one of the fol-
lowing conditions:
• Lower or higher than the STW setting.
• Inside or outside of the STW range setting.
• Equal to the STW setting.
The water temperature alarm is generated in
one of the following conditions:
• Lower or higher than the temperature set-
ting.
• Inside or outside of the temperature range
setting.
• Equal to the temperature setting.
• Vary more than the temperature setting
within one minute (shear).
The depth alarm is generated in one of the
following conditions:
• Lower or higher than the depth setting.
• Inside or outside of the depth range setting.
• Equal to the depth setting.
Reference
4.3.1
4.3.2
4.3.3
4.3.4
4.3.5