Wiring - Furuno RD-33 Operator's Manual

9. INSTALLATION
6. Tighten the knobs to fasten the hanger to the remote display.
9.3

Wiring

Refer to the following illustration and the interconnection diagram (page S-1) to con-
nect cables.
Note: The remote display power is supplied through CAN bus. When the sensor signal
is input or output only from the NMEA 0183 device without the CAN bus device, con-
nect the 12-24 VDC power from the ship's switch board to the male connector of the
CAN bus port.
Interconnection
RD-33 (rear)
Inner dia. φ4
IV-1.25sq
To ground
terminal on hull
FI-50-CHAIN-xxM FI-50-CHAIN-xxM
(0.3 m, 1 m, 5 m, 10 m, 20 m) (0.3 m, 1 m, 5 m, 10 m, 20 m)
M12-05BM+05BF-0xx M12-05BM+05BF-0xx
(1 m, 2 m, 6 m) (1 m, 2 m, 6 m)
CAN bus device CAN bus device
(e.g. NavNet 3D) (e.g. NavNet 3D)
9-4
APP
DISP MENU
TRUE
START
ENT
CLEAR
MJ-A6SPF0003-xxxC
(2/5/10/15 m)
or
The device which
supplies power
For CAN bus For CAN bus For CAN bus For CAN bus
(5P Female) (5P Female) (5P Male) (5P Male)
NMEA port NMEA port
Pi Pin Si Signal l Wi Wire color
1 TD-A
2 TD-B
3 RD-A
4 RD-B
5 NC
6 FG
NMEA 0183 NMEA 0183
Device Device
CAN bus
Pin Signal
1 FG
2 NET-S
3 NET-C
4 NET-H
5 NET-L
For NMEA 0183 For NMEA 0183
l
White
Black
Yellow
Green
Shield
Wire color PWR
Drain
Red +
Black −
White
Blue