Power Connector Cable - HP ProBook 430 G1 Maintenance And Service Manual

Power connector cable

The power connector cable is included in the Cable Kit, spare part number 727757-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5.
Remove the following components:
a.
Service door (see
b.
Keyboard (see
c.
Top cover (see
d.
Display (see
Remove the power cable:
1.
Position the computer upright and open with the front toward you.
2. Remove the cable from the clips in the base enclosure (1).
3. Remove the power cable from the computer (2).
Reverse this procedure to install the power connector cable.
70 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 35).
Service door on page
Keyboard on page 37)
Top cover on page 50)
Display assembly on page
43).
64)