Memory Modules - HP ProBook 430 G1 Maintenance And Service Manual

Memory modules

Description
2-GB memory module (PC3L-12800, 1600-MHz, DDR3)
4-GB memory module (PC3L-12800, 1600-MHz, DDR3)
8-GB memory module (PC3L-12800, 1600-MHz, DDR3)
Before removing the memory module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the service door (see
Remove the memory module:
1. Position the computer upside-down with the battery bay toward you.
2. Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. (The edge of the module opposite the slot rises away from the computer.)
3. Remove the memory module (2) by pulling the module away from the slot at an angle.
NOTE:
memory module slot.
NOTE:
memory sockets.
Reverse this procedure to install a memory module.
Battery on page
Service door on page
Memory modules are designed with a notch to prevent incorrect insertion into the
The computer uses two memory sockets. The removal procedure is the same for both
35).
43).
Component replacement procedures
Spare part number
691739-001
691740-001
693374-001
45