First Aid Section- What To Do; Burns; Reporting Laser Radiation Exposure; Electrocution - 3D Systems ProX DMP320 User Manual

FIRST AID SECTION – WHAT TO DO
In the case of an accident while using any DMP equipment, seek medical attention immediately . Use the following
guidelines for specific safety instances.

Burns

This equipment contains high temperatures and burning laser radiation which could cause 2
any protective panels . There are no user serviceable parts inside .
If a burn occurs, seek first aid and immediate medical attention. Pushing the E-stop button will de-energize the equipment and diffuse
the hazardous situation .

Reporting Laser Radiation Exposure

If the injury was determined to be the result of laser radiation overexposure, please send a report to:
Attention: Laser Safety Officer
3D Systems, Inc .
333 Three D Systems Circle
Rock Hill, South Carolina, 29730
USA
Include the following information in your report:
• Nature of the accident and circumstances surrounding it
• Where the accident occurred
• Model and serial number of the machine
• Number of people involved
• Any other pertinent information
Please send this information to 3D Systems within a day of the accident .

Electrocution

The DMP system contains equipment energized at 400 volts . Do not attempt to remove protective panels . There are no user
serviceable parts inside .
If electrocution occurs, seek first aid and medical attention immediately. Pushing the E-stop button will de-energize the equipment and
diffuse the hazardous situation .

Material Inhalation

The material handling process may create a choking or air restriction hazard. If someone has difficulty breathing or a "loss of breath"
sensation, transport the person to a well-ventilated room or outside of the facility . If the condition persists, seek immediate medical
attention .

Powder ingestion

Quickly wipe material from mouth and rinse with water . Do not induce vomiting . Seek medical attention if symptoms occur or when
unsure .

Powder skin contact

Powder contamination of the skin may cause soft tissue irritation and/or an allergic reaction . Remove contaminated clothing and
dispose of or properly launder . Brush material off skin, wash affected area with soap and water . Seek medical attention if symptoms
persist .
Powder eye contac
t
Even non toxic powders may cause soft tissue irritation and/or an allergic reaction . If someone gets powder in his/her eyes immediately
rinse eyes gently but thoroughly with lukewarm water . Also rinse under upper and lower eyelids, for at least 10 to 20 minutes . Seek
medical attention when symptoms persist . Eye wash station must be present in the vicinity of all powder operations .
NOTE: For more specific information regarding first aid in relations to powder, see the applicable SDS sheet.
3D SYSTEMS, INC.
degree burns . Do not attempt to remove
nd
8