The Lnvisiball ™ Mounting System - REVELL M55XC Owner's Manual

INVISIBALL MOUNTING SYSTEM
The InvisiBall is a unique method of mounting a loudspeaker. The
™
InvisiBall is designed to be unobtrusive, offer theft deterrence,
™
and simplify the installation while offering tremendous flexibility in
positioning the loudspeaker.
NOTE: Your installation of this loudspeaker must be done in
conformity with local building codes. Please consult with a
licensed contractor or professional engineer on any installation
in which the loudspeakers are mounted on a ceiling or wall.
Revel is not responsible for damages resulting from the negligent
installation of any bracket or loudspeaker.
1. Install the lnvisiBall mount on the wall using the screws as shown
™
in Fig. 1. Again, be very certain that the type of anchor is appropriate
for the wall material, and that the wall material will support the
weight of the loudspeaker.
2. Stick a wide tipped, slotted screwdriver in the slot of the plastic
InvisiBall knock-out plug and push downward, thereby breaking the
™
plug out of the back of the speaker as shown in Fig. 2. Be sure the
ball will fit in the hole by scraping away any residual plastic around
the hole.
1
Mount to wall
4
Open rubber plug, insert Allen wrench,
loosen clamp
XC Series Outdoor Monitors
Owner's Manual
3. Remove the grille from the speaker enclosure to access the rubber
plug located in the center between the tweeter and woofer. Pull up
on the rubber plug to expose access for the Allen wrench to loosen
the internal mounting clamp. The plug can be rotated to move it out
of the way for the Allen wrench.
4. Insert the supplied Allen wrench into the hole exposed behind the
rubber plug. Lightly push and slowly rotate the Allen wrench until
you feel the wrench fall into place. Loosen the InvisiBall
shown in Fig. 4.
5. Mount the speaker on the InvisiBall
6. Tighten the clamp just enough to hold the speaker while you position
it in the desired orientation as shown in Fig. 6. When the speaker is
pointing just the way you want it, tighten it firmly and replace the
rubber plug in the hole on the speaker baffle and re-attach the grille.
CAUTION: DO NOT OVERTIGHTEN.
2
Pop Plug
5
Mount speaker
as shown in Fig. 5.
™
3
Remove grille
6
Position speaker, tighten clamp, replace grille
Recommended InvisiBall Tightening Torque:
26-34 pound/inch / 30-40 kgf.cm
DO NOT OVERTIGHTEN!
clamp as
™
3