DOCUMENTATION CONVENTIONS This document contains general installation instructions for the Revel I20/I30 Back Box. It is important to read this document before attempting to use this product. Pay particular atten- tion to safety instructions. WARNING Calls attention to a procedure, practice, condition, or the like that, if not correctly performed or adhered to, could result in injury or death.
Page 5
WARNING The I20 Inwall Back Box weighs 19 lbs. (8.6kg) empty, and weighs 32 lbs. (14.52kg) with an I20 speaker system installed in it. The I30 Inwall Back Box weighs 19 lbs. (8.6kg) empty, and weighs 36 lbs. (16.3kg) with an I30 speaker system installed in it.
2x4-inch (or 2x6-inch) wall studs on 16-inch centers. See the illustrations below for inner dimen- sions. Figure 1: I20 Back Box Height & Width Place side flange This flange fits in between wall studs on top of stud...
Page 7
Figure 3: I20/I30 Back Box Depth 3.375-inches (85.7mm) Front Rear Note Figure 3 (above) shows the depth of the back box. It can be installed in walls con- structed with standard 2x4s. It is impor- tant to note that the speaker mounting...
Page 8
Loosen the terminal connec- tors by hand (counterclockwise) on the terminal cup’s positive (+) and nega- tive (-) binding posts. REVEL I20/I30 Back Box Installation Instructions Note The terminal cup can be removed from inside the back box if it is necessary to retighten the amplifier cable connections.
Page 9
10. Fasten the drywall to the wall studs using drywall screws. 11. Install the speaker mounting frame into the wall opening. Refer to the Revel I20/I30 In-Wall Loudspeaker Owner’s Manual for complete instruc- tions. Figure 6: Cut Opening in Drywall...
REVEL I20/I30 Back Box Installation Instructions Exposed Binding Post Terminal Connectors 16. Refer to the Revel I20/I30 In-Wall Loudspeaker Owner’s Manual for complete instructions on installing the speaker baffle to complete the installa- tion. I20/I30 BACK BOX...