Prox 500 Sls 3D Printer - 3D Systems ProX 500 Original Instructions Manual

ProX 500 SLS 3D Printer

Supplied by: 3D Systems
Installed by: 3D Systems
The printer requires a 3-phase, 208 VAC, 50/60 Hz, 10 kVA power source and a separate
source .
Ceiling drop lines for nitrogen supply and exhaust, electrical, and clean dry air (CDA) are recommended. The floor below the process
station must be flat and vibration-free. The room must be air-conditioned, with no vents directly above the machine. Clearance around
the process station is required so hinged access panels can be fully opened . See the
Poster on page 33
for clearance requirements .
A
3D Systems, Inc.
C
D
B
E
Chiller
ProX 500 SLS 3D Printer Facility Requirements
A
Stacklight: Indicates the state of the system .
Print Chamber Area: There are two doors in
B
front of the Print Chamber—the outer locking
door, and the inner print chamber door . The
parts are printed inside the Print Chamber .
E-Stop: The Emergency Stop button is a
C
safety mechanism used to shut off the
F
machine in an emergency situation in which it
cannot be shut down in the usual manner .
User Interface (UI): The user controls the
D
system using a touchscreen located on the
front panel .
LED Interface Lights and Controls: There
E
are three LED lights which give the user visual
feedback regarding the system . The two
buttons allow the user to control the chamber
lights and enable the system . There are two
standard USB ports beneath them .
User and Service Access Panels: There are
F
two types of panels on the sides and back of
the machine—user access and service
access . The user access panels are hinged
doors . The service access panels are lift-off
panels . A tool is required to open each panel .
5
with its own single-phase power