How To Prepare For Installation; Safety Precautions; When You Are Ready For Installation - 3D Systems ProX 500 Original Instructions Manual

Hide thumbs Also See for ProX 500:

Table of Contents

HOW TO PREPARE FOR INSTALLATION

Use this guide to help you prepare your facility for installation of the:

•

ProX™ 500 SLS (Selective Laser Sintering) 3D Printer

•

ProX Material Quality Control (MQC) System

•

Auxiliary equipment for finishing parts created with the ProX 500

This guide gives you the information and guidance you need to complete the

Printer and Auxiliary Equipment on page

have your equipment installed .

You will find all

Contact Information on page 31

At the back of this guide, you will find the ProX 500 Facility Posters which give you a layout view of the facility requirements for the

ProX 500 SLS 3D Printer, ProX Material Quality Control System, and auxiliary equipment .

Please review all safety information in the

Once your facility is ready and you have scheduled an installation date with 3D Systems' Customer Support, read

and Storing the System on page

This will show you how to properly unpack the ProX 500 3D Printer, MQC System, and auxiliary equipment and move them into place .

CAUTION: After you receive your equipment, do not allow anyone to connect electrical power, compressed air, or

nitrogen to any of these devices. This must only be done by your 3D Systems-certified Customer Support Engineer

(3D CSE) during installation .

Attempts to install equipment or auxiliary equipment by non-3D Systems-certified personnel could void the warranty

and result in serious injury and equipment damage .

3D Systems, Inc.

15 . You must complete this checklist and send it to 3D Systems when you're ready to

for 3D Systems' service and support .

Safety Guidelines and Instructions

22 .

Facility Requirements Checklist - ProX 500 SLS 3D

ProX 500 User

section of the

Guide.

Receiving, Moving,

Table of Contents