Invacare Bora XTR Series Service Manual page 9

1. Remove seat plate (1) or sling seat, see Modulite Service Manual,
chapter "Adjusting seat width".
2. Loosen Allen screws (2) in front and rear, left and right – DO
NOT remove.
Seat depth setting
Adjust the seat depth using the profile scale (1) in accordance with the following table: Example: Setting value 1,5
Flex3 backrest / with seat
plates
Seat width 38 cm
Seat width 43 cm
Seat width 48/ 53 cm
Flex3 backrest / sling seat
Seat width 38 cm
1528338-P
Profile length
51 cm
51 cm
54,5 cm
Profile length
51 cm
51 cm
54,5 cm
Profile length
51 cm
51 cm
54,5 cm
Profile length
51 cm
51 cm
3. Shift position of seat frame.
4. Re-tighten screws.
5. Install seat plate again.
Screw on position of the seat frame
The center of gravity of the seat can be adjusted by mounting the seat
frame (1) farther towards the front or the rear on the seat support
(2), see Modulite service manual. If the mobility device is used with
drive lock-out choose different screw positions, for example:
Screw on position of the seat frame (1) with Flex3
backrest, seat depth 51 cm
Screw on position of the seat frame (1) on the seat
support (without drive lock-out)
Seat depth
41 cm
46 cm
51 cm
Seat depth
41 cm
46 cm
51 cm
Seat depth
41 cm
46 cm
51 cm
Seat depth
41 cm
46 cm
Setting value / profile scale
4,5
2
1
Setting value / profile scale
5
2,5
1,5
Setting value / profile scale
5,5
3
2
Setting value / profile scale
3,5
1
Setup
9