Invacare® Bora® / Spectra® XTR Series
Kite lifter-tilt
bracket
Pronto M41
bracket
Bora model graphics have been used in the following
sequence.
1.
Remove legrests.
2.
Tilt seat tilting completely to the rear if possible.
3.
Switch controls OFF on the remote.
4.
Remove backrest cushion.
5.
Loosen and remove screws, which secure the middle seat plate
A with a 3 mm Allen key.
Remove middle seat plate B.
6.
7.
Loosen and remove screws on both sides with a 3 mm Allen key,
which secure lateral seat plates C.
Remove lateral seat plates D. Or:
8.
36
9.
Remove seat cushion.
10. Loosen and remove screws on both sides, which secure sling
seat A with a T25 Torx wrench.
11. Remove sling seat B.
12.
Remove seat frame by removing screws (1) with a T40 Torx
wrench.
13.
Disconnect actuator cable and microswitch cable from cable
harness.
14. Loosen and remove screws (2) incl. washers with a 5 mm Allen
key.
15. Lift module of the tilt (1) from the adapter and replace it.
16. Installation takes place in reverse order.
17. To complete, check all seat tilting functions.
1528338-P