Thermo Scientific Micro-Tech 9101 Reference Manual page 199

No. Parameter
Enter time for
revolutions to pass
reference
13 Auto Zero tracking
14 Auto zero tracking
range +/-
15 Auto zero tracking
step +/-
16 Auto zero tracking
max dev. +/-
17 Auto zero tracking
Warm Time
18 Auto zero tracking
Test duration
19 Max. speed capacity
20 Auto Zero max dev.
21 Zero Reference
Thermo Fisher Scientific
Selection
(10 - 16200 sec)
no, yes
4.0% (0-10)
0.02% (0.01 – 10 )
4.0% (0-10);
(0-2)*
(0-5)**
1.0 (0-160 min)
1-L, 1-S
600.0 (1 - 2000 FPM)
2% (0-2%)
INVALID (0 - 120000)
Description
Time required for minimum number of
revolutions (seconds).
The AZT sequence starts automatically when
the flow rate is below this percentage of the
max scale capacity.
*NTEP W&M mode.
**NTEP W&M mode when print AUTO ZERO
is enabled under the PRINT scroll.
Generates an alarm when the change from
the Zero Reference value to the value of zero
with new factor applied exceeds the max
deviation.
Only available when Nr. of test duration is set
at 2.
This scroll is only available when NTEP
W&M mode is selected.
Generates an alarm when the change from
the Zero Reference value to the new zero
value exceeds the max deviation.
The base value for Autozero max deviation
and Autozero Track max deviation. This
value must be re-set to clear a Autozero or
Autozero Track max deviation alarm.
Micro-Tech 9101/9201 Reference Manual, Rev J B-27