Hach AMTAX sc User Manual page 39

5.2 Sensor setup menu (continued)
CONFIGURE (continued)
SAMPLE DETECTION
OFF/WARNING/ERROR
EXHAUST CONTROL
ON/OFF
ELECTROLYTE
WARNING/OFF
FALSE ELEC DATA
ERROR/OFF
DEFAULT SETUP
LAST CHANGE
MAINTENANCE
INFORMATION
LOCATION 1
LOCATION 2
TYPE
SENSOR NAME
SERIAL NUMBER
RANGE
OPTION
SOFTWARE PROBE
SOFTW. AMTAX
LOADER
APPL
STRUCTURE
FIRMWARE
CONTENT
LANGUAGE
CALIB. DATA
LOCATION1
GAIN CORR
DATE
LOCATION2
GAIN CORR
DATE
mV ZERO
mV STANDARD 1
mV STANDARD 2
mV SLOPE
LAST CALIBRAT.
mV ACTIVE
Determines instruments reaction when amount of available sample is too low. When
instrument is in filter probe mode, deactivating the sample detection will switch a deactivated
"STATUS MODUL.ERR" to 14 %
Determines instrument reaction when drain is blocked
Determines whether a warning is initiated when electrolyte level is low/ last change of
membrane is more than 90 days ago.
Determines whether an error is initiated when the mV-Zero value of the electrode is not within
a certain range (see list of errors)
Resets factor and settings to factory settings.
Indication of the last change of a setting in the configuration menu.
Indication of measuring location 1
Indication of measuring location 2 on two-channel version
Indication of instrument type
Indication of instrument name
Indication of serial number
Indication of measuring range
Indication of instrument option (filtration probe/1-channel/2-channel)
Filtration probe software
Instrument software
Detailed information on the software in the instrument
Detailed information on the software in the instrument
Detailed information on the software in the instrument
Detailed information on the software in the instrument
Detailed information on the software in the instrument
List of languages that are supported by the installed language package.
Indication of measuring location 1
Indicates the correction factor set for correcting the measured values at measuring location 1.
Indicates the date of the last change to the correction factor.
Available with the 2-channel version.
Indicates the correction factor set for correcting the measured values at measuring location 2.
Indicates the date of the last change to the correction factor.
Electrode signal at the zero point
Electrode signal with standard 1
Electrode signal with standard 2
Electrode signal change per decade
Time of the last calibration
Current electrode potential
Operation
39