Table of Contents
Advertisement
Installation
3.2 Unpack the instrument
3.3 Mechanical installation
3.3.1 Mount the instrument
3.3.1.1 Wall mount
14
CAUTION
Pay attention to the weight (approximately 31 kg) of the
instrument. Do not try to carry the instrument without
assistance. Use only suitable lifting tackle for transport.
Open the shipping container while it is on its end and then slide the
analyzer out of the cardboard. The items supplied will vary
depending on the order. Standard items supplied for a minimal
configuration include:
•
AMTAX sc and user manual
•
Collecting tray
•
Initial set of reagent and cleaning solutions
2 standard solutions and electrolyte / membrane caps
•
Fastening bracket and angle bracket
•
Accessories for tubing and flow-through variant
•
Plug set
Select a suitable place to install the instrument. Plan the
mechanical installation before positioning posts or drilling holes.
Refer to
Figure 1, page
dimensions.
Make sure that the fastening has sufficient load bearing capacity
(approximately 160 kg). The wall plugs must be selected and
approved to suit the properties of the wall.
Plan cable and tubing routes to avoid sharp bends and tripping
hazards.
When connecting two analyzers (e. g. for measuring two
parameters with a FILTRAX or Ultrafiltration), plan where the
instruments are to be installed and consider the length of the
heated drain tubing (2 m).
The AMTAX sc can be mounted in three different ways:
•
Wall Mount
(section
•
Rail Mount; refer to the instruction sheet supplied with the
Rail Mounting Hardware.
•
Stand Mount; refer to the instruction sheet supplied with the
Rail Mounting Hardware.
Refer to
Figure
5,
Figure 6
analyzer to a wall.
1. Align and install the fastening bracket to the wall.
2. Attach the angle bracket to the instrument using the
supplied screws.
3. Slide the bottom of the enclosure onto the fastening bracket.
7,
Figure 2, page 8
for instrument
3.3.1.1),
and following instructions to mount the
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
