Hach AMTAX sc User Manual page 115

Tag name Register #
SET OUTMODE
40086
CAL.
DISCHARGE
40087
CLEAN.
SET OUTMODE
40088
CLE.
SET OUTMODE
40089
SER.
LOCATION2 40090
SET PARAMETER 2 40098
GAIN CORR. 2 40099
MEAS.UNITS 2 40101
HUMIDITY ANALY 40102
SOFTWARE
40103
PROBE
HUMIDITY PROBE 40105
PROCESS STATE 40107
LAST CALIBRAT. 40108
START BY BUS 40110
FIELDBUS 40111
NUMBER OF
40112
MEAS.
DISCHARGE BUS 40113
AVERAGE 40114
Table 13 Sensor Modbus registers (continued)
Data
Length R/W
type
Unsigned
1 R/W
Integer
Unsigned
1 R/W
Integer
Unsigned
1 R/W
Integer
Unsigned
1 R/W
Integer
String 8 R/W
Unsigned
1 R/W
Integer
Float 2 R/W
Unsigned
1 R/W
Integer
Unsigned
1 R
Integer
Float 2 R
Unsigned
1 R
Integer
Unsigned
1 R
Integer
Time2 2 R
Unsigned
1 R/W
Integer
Unsigned
1 R/W
Integer
Unsigned
1 R/W
Integer
Unsigned
1 R/W
Integer
Unsigned
1 R/W
Integer
Fieldbus Communications
Discrete Min/Max
Description
range range
Set output mode for calibration;
0/1 —
0=HOLD, 1= TRANSFER VALUE
— 0/10 Discharged values after a cleaning
Set output mode for cleaning;
0/1 —
0=HOLD, 1= TRANSFER VALUE
Set output mode for service mode;
0/1 —
0=HOLD, 1= TRANSFER VALUE
Location for the measuring channel
— —
two for the sample
Select the parameter for channel 2;
19/42 —
19=NH4-N, 42=NH4
— 0.01/100 Gain correction for channel two
.00
Measurement units for channel 2;
0/2 —
0=mg/L, 2=ppm
— 0/100 Humidity analyzer in percent
0/3.4028 Software version of the filtration
—
2347E+ probe
38
— 0/100 Humidity filtration probe in percent
Process status is coded as enum
list; enum value 0=service mode,
enum value 1=citrocal in proc, cal1
in proc., cal2 in proc., measuring
0/1/2/3/4/
1..., interval, initialisation, serv.in
5/6/7/8/9/
proc., cleaning, warm up phase,
10/11/12/ —
measuring 2..., prepump reag.,
13/14/15/
prepump clean.,prepump standard,
16/17/18/
prepumping probe, flushing, start by
19/20
BUS, warming up, reserved,
prepump.sample; enum value
20=validation
— — Date of the last calibration
To set the analyzer to START BY
0/1 —
BUS mode (see Start by BUS)
To trigger a measurement serie in
— 0/2 START BY BUS mode (see Start by
BUS)
Number of measurements in a
— 1/100 START BY BUS measurement
series (see Start by BUS)
Discharge values at the beginning
— 3/10
of a START BY BUS series
Number of measurement values
that result in an average value in a
— —
START BY BUS measurement
series.
115