Specifications; Set Up; Installing The Motor Unit; Installing The Control Box - JUKI SC-922 Instruction Manual

I .
SPECIFICATIONS
Supply voltage Single phase 100 to 120V
3-phase 200 to 240V Single phase 220 to 240V
Frequency 50Hz/60Hz
50Hz/60Hz
50Hz/60Hz
Operating envi- Temperature : 0 to 40"C
Temperature : 0 to 40' C
Temperature : 0 to 40 C
ronment Humidity : 90% or less Humidity : 90% or less
Humidity : 90% or les_ s __
Input 310VA 310VA 310VA
• The electric power is a reference value for the model equipped with the LU-1510N-7 machine head .
It differs by the selected machine head.
n.
SET-UP
1. Installing the motor unit
0
2. Installing the control box
1) Attach bracket
0
supplied with the unit using
four supplied screws (M5 x 1 O) as shown in the
f1gure.
Install the motor unit on the table with the fitting bolt
asm. supplied with the unit as accessories.
At this time, insert the nuts and washers supplied
with the unit as accessories as shown m the figure
so that the motor unit can be securely llxed on the
table.
1 ) Press three bolts
0
supplied with the unit as ac-
cessories into the motor hanging bolt hole m the
table and fix them.
2) Temporarily tighten convex washer, spring wash-
er and nut on the side where two bolts are at-
tached.
3) Hang the motor unit to the washer which has
been temporarily tightened, and attach convex
washer, spring washer and nut to the other bolt
on the
oppos~e
side.
4) After adjusting the installing pos1tion of the motor,
securely tighten the respective nuts.
2) Loosen four screws
8
supplied w1th the motor
unit as accessories. tighten screws f) after hang-
ing control box unit
0
to the screws, and fix con-
trol box unit
0 .
-1-