JUKI SC-922 Instruction Manual page 17
Hide thumbs
Also See for SC-922:
- Instruction manual (58 pages) ,
- Engineer's manual (82 pages) ,
- Supplementary instructions manual (160 pages)
Table of Contents
Advertisement
[In
case
of using the power switch for LA]
JA 3o 220V
Red
AC
Black
}
U
~---__;:::~~II:J::>)
200V-240V
White
JA 1o 120V
Green
I
Yellow
(ground
wire)
E
Biack
}
AC
b
~
====J~~-
0
White
100V-120V
0
Green
I
Yellow
(ground wire)
Connect motor output cord
Q)
to connector
0
locat-
ed on the side of the
box.
Installing power switch
Connect power supply cord to the power sw1tch.
[JA specifications]
3-phase 220 V
:
Power supply cords
:
black,
white
,
red and
green/
yellow
(ground wire)
Single phase 120V
:
Power supply cords
:
black
,
white,
and green/yellow (ground
wire)
When the metallic conduit is used, be sure to change over the power cord section following the steps of pro-
cedure described below
(Caution)
Be sure to carry out this procedure before installing the control box on the machine
table.
(1)
Place the control box with its frame side down on
the machine table as illustrated in the
sketch
.
(2)
Loosen screw
CD
in underside cover
0
to open
the
cover.
3
Change over the cord shown in the red-line circle
following the steps of procedure described
below.
-9-
Advertisement
Table of Contents
