JUKI SC-922 Instruction Manual page 13

1) Pass cords
0
of the thread trimmer solenoid,
reverse feed solenoid an d detector cords
8
through table hole
0
and route them under the
table.
2) Loosen screw €) in cover
8
with a screwdriver to
open the cover.
3) Conn ect 14P code
8
coming
from t he machine head to con -
nector
0
(CN36) .
4)
When the opt1onal AK dev1ce
is attached , connect 2 P con -
necto r
0
coming from the AK
dev1ce to connector
G
(CN37)
5) Inse r t co n necto r
0
commg
from the detector into connec-
tor
0
(CN33).
6) Connect connector
tD
coming from the motor to connector G) (CN30) on the circuit board.
(Caution) 1. When using the AK device, set whether to use the AK device after confirming how to select
the auto-lifter function. (Retter to " m-11 . Setting of the auto lifter funct ion" p. 43.)
2. Be sure to securely insert the respective connectors after checking the inserting direc-
tions since all connectors have the inserting directions. (When using a
type
with lock, in-
sert the connectors until they go to the lock.) The sewing machine is not actuated unless
the connectors are inserted properly. In addition, not only the problem of error warning
or the like occurs, but also the sewing machine and the control box are damaged.
[Connecting the connector for the operation panel]
The connector for t he operation panel is provided .
Paying attention to the orientation of the connector
45.
connect it to connector
(CN 38)
41) located on the
circuit board. After connecting, securely lock the con·
nectar.
(Caution) Be sure to turn OFF the power before
c onnecting the connector.
- 5 -
1
I
1
I
I
I
I
I
I
I
I
I
I
I
I
I
I