One-Touch Setting - JUKI SC-922 Instruction Manual

4. One-touch setting
A part of function setting items can be easily changed in the normal sewing state .
(Cautio n) For the s etting of functions other than those covered In this part, refer to
•m-6.
Setting of func-
tions of SC-922" p.23.
&JUKI
CP-1 8
(Caution) The setting Is confirmed by pressing
Q)
switc h f).
(1
Thread trimming function ( (
r
n)
[One-touch setting procedure]
1) Keep
Q)
switch f) held pressed
for one second to place the panel in
the function setting mode .
2) Change over the item to be set by
using
9
sw1tch f) or
@
switch
...
...
0 .
Then , the set value can be
changed by using
8
sw1tch
0
and
(±) switch 0
3) To return to the normal sewing state,
press
Q)
switch f).
o
F F
:Thread trimming operation is not performed (solenoid output prohibition: Thread trimmer, wip-
er)
o
n
:Thread trimming operat1on is effect1ve.
2
Wiper function (
J:l ,
P )
o
F
F :
Wiper does not operate after thread trimming
ming
3
One-shot automatic stitching functiOn (
5
H
D
r )
o
n :
Wiper operates after thread trim-
o
F
,C :
One-shot autom atic stitching function is ineffective.
o
n :
One-shot automatic stitching is effec-
tive.
(Caution) This function is rendered effective when the material end sensor function Is set. It Is not pos-
sible to prohibit the one-shot operation duri ng overlapped sewing operation. The number of
revolution Is the value which Is set for setting No. 38.
4
Settmg of the max. speed of stitch (
5 P d )
The highest speed of stitch of the machine head is set. The upper limit of the set value differs with the
type of machine head to which the SC is connected.
Setting range : 150 ·Max. value [sti/min]
s Material end sensor function (
f
d)
o
F F .
Matenal end sensor function
IS
ineffective.
0
n
: Once the material end 1s detect ed, the sewing machine stops running after having sewn the
number of stitches set With
7 (
E d 5
r ) .
• This function is rendered effective when the optional material end sensor is connected to the sewing machine.
6
Thread trimming function by matenal end sensor (
E d
r
r )
0
F F .
Automatic thread trimm1ng function after the detect1on of material end
IS
meffect1ve.
0
fl .
On ce the material end is detected, the sewmg machine performs thread t rimming after having
sewn the number of stitches set with
1)
<
E d 5
r
> ·
• This function is rendered effective when the optional material end sensor is connected to sewing machine.
7
Number of stitches for material end sensor (
E d 5
r )
The number of stitches to be sewn from the detection of material end to the stop of the sewing machine
Number of stitches that can be set: 0 to 19 (stitches)
(Caution) If the number of stitches specified is inadequate, the sewing machine can fail to stop within the
preset number of stitches depending on the number of revolutions of the sewing machine.
-19-