Poe Connection; Basic Operations Guide; Power On And Off; 1Power On - CPcam CP-NVR-8CH User Manual

5.5 POE Connection


Non-safe voltage 48V, please pay attention to electrical safety.Supply the NVR with the 12V DC power.

IP Camera should support the POE.

The theoretical distance of POE power supply should below 100 meters.

6.1 Power On and Off

6.1.1 Power On
Install the DVR/NVR correctly (as above) and then connect the power. The DVR/NVR LED should light up and
the DVR/NVR will boot automatically.
The DVR/NVR will then automatically detect any connected hardware (cameras, monitors, etc.), this process
should last about 30 Seconds. When this process has been completed the DVR/NVR will enter the multi-screen
real-time surveillance mode.
If your hard drive is not properly connected, the following message will appear on your screen.
：
Note Please do not use any type of power supply which is different from the power supply included in this
kit.

6 Basic Operations Guide