Overview - Intec Force 1 Instruction Manual

THE FORCE/1

Overview

Three subsystems make up your FORCE/1:
THE AGITATOR AND AIRLOCK.
horsepower motor driving an enclosed gearbox. The airlock positions
the material for proper distribution by the blower.
THE BLOWER MOTOR.
104 CFM two-stage blower motor to push the material through the hose
and into the attic with optimum pressure and output. The blower is
connected to the air intake port of the airlock by a metal sleeve.
ELECTRICAL COMPONENTS.
dedicated 20 amp grounded power supply. Less amperage will likely
trip circuit breakers. Always disconnect
the power source before beginning any
maintenance. And as with all electrical
systems, never attempt to operate your
FORCE/1 with either the operator or the
machine standing in water.
(see next page for drawings)
THE PARTS
A. Hopper: upper component of the FORCE/1 where insulation
is loaded.
B. Base: lower component of the FORCE/1 houses power
components, blower and airlock.
C. Slide gate: increases or decreases the amount of material
entering the airlock.
D. Electrical: on/off function of both the blower and agitator
motors.
Your FORCE/1 runs on a
Your FORCE/1 is equipped with a
Your FORCE/1 requires a
6
⁄
3
4