Intec Force 1 Instruction Manual page 15

THE FORCE/1
Set-U p and Operation, Cont.
Always clean unused material out of the hopper, airlock, and hose at the
end of each job.
Do not put your hands inside the hopper while the machine is
running. If a tool or other foreign object accidentally falls into the hopper,
turn the machine off immediately. Careless operation of this machine can
result in bodily injury.
ADJUSTING SLIDE GATE:
The pin-set slide gate regulates the
amount of material entering the
airlock. By adjusting the slide gate,
you increase or decrease both the
amount of material and the material
throw distance from the hose. To
increase material flow, pull the slide
gate out; to decrease push the slide
gate in.
Overloading the hopper or
pushing
material in the hopper
can cause
problems or jamming
which
your machine. When
loading
empty only one bag at a
time into the hopper. Wait
until half the contents have been
used before adding another bag.
Slide Gate Adjustments
14
down on the
electrical
can damage
your machine,