Intec Force 1 Instruction Manual page 16

THE FORCE/1
Set-U p and Operation, Cont.
LOADING THE HOPPER:
ing. Cellulose, place the bag of insulation material on the hopper. Use a
knife to open the bag so that the material falls into the hopper. Your
FORCE/1 is designed to self-feed. Fiberglass, place the bag on the side of
the hopper. Cut the bag in thirds and dispense one third of the contents
gradually until the agitator breaks up and conditions the material. Load
the remainder of the material according to the distribution rate. Empty
no more than 1⁄3 bag at a time into the hopper, waiting until at least 1⁄4
of the material has been used before adding additional insulation.
Forcing insulation material will cause overloading, electrical fail-
ure or possible machine damage.
If the agitator stops or the circuit breaker on the electrical panel trips,
unplug the machine from electrical power. Remove the cause of the jam
from the hopper. You may have to empty all the insulation material to
locate and remove the jam. After clearing, reset the circuit breaker,
reconnect power and continue normal operation. See page 22 for more
information on unjamming.
Fiberglass Insulation Only: Cut as
shown and break bag into three sections
Machine may be "on or off" while load-
15