Menu System; System Setup Menu - Signet 9900 Operating Instructions Manual

Menu System

System Setup Menu

All of the basic system setup functions are automated in the
9900 for many sensors and sensor electronics. This includes
identifying the sensor connected to the 9900, and confi guring
the display for the sensor. After installation and wiring is
completed, apply power to the 9900.
When the 9900 is fi rst powered on, it will attempt to determine
the sensor type connected when ENTER is pressed (unit will
display LOOKING FOR).
If no sensor is attached to the 9900, the words "TYPE" and
"FLOW" are displayed.
If the 9900 does not identify your sensor type correctly,
use the ▲ and▼ keys to select your sensor type.
As you scroll through the available sensor types, press ► to
select the desired sensor and then press ENTER.
You may change sensor type after initial
power-on (if the sensor type is changed
after your 9900 is already in service).
Enter the INPUT menu, scroll to TYPE,
press ►, and scroll to select the desired sensor type
(you may be prompted for your password).
Press ENTER. The bottom line will display ALL SETTINGS
WILL BE RESET. ARE YOU SURE? The top line of the
display will blink NO (unless switching from Factory mode).
Press ▼ or ▲ to select YES.
Press ENTER again to finalize your selection.
NOTE: User is strongly discouraged from changing the
sensor type away from the correct sensor.
ENTER
Sensor Choices
NOTE:
The 9900 displays the BATCH instrument type
ONLY if the Batch Module is installed.
9900 Transmitter
ENTER
25