Batch Module; To 20 Ma Output Module - Signet 9900 Operating Instructions Manual

Batch Module

Mfr. Part No. Code
3-9900.397 159 310 163
Convert a 9900-1P Transmitter (Generation II** or later) into a Batch Controller system by
utilizing a Batch Module (3-9900.397) and a Relay Module (3-9900.393).
Optional Module Wiring:
● Wire an external button or keypad (customer supplied) to stop, start or resume
a batch remotely.
● *Wire an external input that can inhibit a batch from starting.
Full 9900-1BC Batch Controller System manual available at www.gfsignet.com
3-9900.397
Batch Module
Start
Stop/Inhibit
Resume
Common

4 to 20 mA Output Module

Mfr. Part No. Code
3-9900.398-1 159 001 784
The optional 4 to 20 mA Output Module adds an additional 4 to 20 mA loop output to a
Signet 9900 Transmitter (Panel or Field Mount). Requires the 9900 Generation III** or later.
Features:
● 4 to 20 mA Output Module can be powered using Loop Power or DC Power in the
9900 base unit.
● Independent settings for the loop currents of the Output Module and 9900 base unit
(Error, Loop Adjustments, etc.).
● The Primary or Secondary (if applicable) measurement of a compatible sensor can
be selected as the loop source.
● The same source (Primary or Secondary measurement) can be used for Loop 1 in
the 9900 base unit and Loop 2 in the Output Module.
6 9900 Transmitter
Description
Batch Module
Common
Description
4 to 20 mA Output Module
Red
PWR+
+
PWR– Black
10.8 to 35.2 VDC
–
Loop+
Loop–
Loop2+ PLC or Recorder
Loop2– Blue
+
–
PLC or Recorder
Blue
+
–
Start
Stop
Inhibit*
Resume
Power Supply
Loop 1 Input
4 to 20 mA
Loop 2 Input
4 to 20 mA
** NOTE:
Verify 9900 Transmitter
generation in the
OPTIONS Menu.
NOTE:
The 4 to 20 mA Output,
Direct Conductivity, and
Batch Modules share the
same installation site on
the 9900 base units.
Only one of these
modules can be used
per 9900 Transmitter.
NOTE:
The Output Module can
run on Loop Power.