Signet 9900 Operating Instructions Manual page 41

Level / Volume
INPUT Menu
Enter 13-character string (optional). Default = LEVEL/VOLUME.
Select between Level or Volume.
Default = LVL.
Select unit of measure for LEVEL display (FT, IN, M, CM).
Default = FT
ON = Measurement will be displayed as a percentage of full scale.
OFF = Measurement will be displayed in unit of measure selected in previous setting.
Default = OFF.
If PERCENT LEVEL = ON, set the desired full scale (100%) value in units of measure.
Default = 10.00.
Select unit of measure for VOLUME display (GAL, LIT, Lb, KG, FT , in , M , cm ).
3 , 3 3 3
Default = GAL.
Select ON = Measurement will be displayed as a percentage of full scale. OFF = Measurement will be
displayed in unit of measure selected in previous setting.
Default = OFF.
If PERCENT VOLUME = ON, set the full scale value (100%) in units of measure.
Default = 100.00.
Enter the specifi c gravity of the fl uid at normal operating temperature. This setting is required only if the
level measurement is made by a pressure sensor or if kg or lb volume units are selected.
Default = 1.0000 (water).
Enter the distance from sensor location to the Zero reference point in the vessel (see discussion in
Appendix). Displayed in units of measure chosen in LEVEL UNITS.
Default = 0.
Dampens display, output and relay response rates.
Select Low, Med, High, OFF (see discussion in Appendix). Default = OFF
Select the shape of the vessel where the level sensor is located. VERT CYLINDER, HORIZ
CYLINDER, RECTANGLE, or CUSTOM.
(To defi ne a custom tank shape, see Appendix page 52, Defi ning a Custom Tank.)
Default = VERT CYLINDER.
If VERT CYLINDER or HORIZ CYLINDER is selected, enter the diameter of the cylinder. Displayed in
units of measure chosen in LEVEL UNITS.
Default = 2.0000
9900 Transmitter 41