Nufer Medical CERATHERM 600-3 Instruction Manual page 8

8
Instruction Manual CERATHERM 600-3
Operation: Switches unit on and off (observe chap. 8)
Display: The unit's operating mode (observe chap. 8)
Operation: Alarm confirmation (observe chap. 8)
Display: Alarm (observe chap. 8 and safety guidelines in chap. 2)
Operation: Preset heat level 1 (20% output)
1
Display: Heat level 1 active
Operation: Preset heat level 2 (50% output)
2
Display: Heat level 2 active
Operation: Preset heat level 3 (75% output)
3
Display: Heat level 3 active
Operation: Preset heat level 4 (98% output)
4
Display: Heat level 4 active
Display: Heating active (observe chap. 8.3)
Operation: Lighting 20% on/off (observe chap. 9)
Display: None
Operation: Lighting 100% on/off (observe chap. 9)
Display: None
Operation: Master switch (supply voltage on/off, see chap. 7)
Display: Mains supply on
Potential equalisation connection.
If the unit is used in a room that corresponds to Category 3 or 4 under
Swiss Low-Voltage Installation Standard NIN / 7.10, this connection must
be connected to the room's potential equalisation connection.
14.171.C_GA_Ceratherm_600_3_EN.docx Nufer Medical AG / 04.07.2014 / DU Seite 8 / 32