Operation; Master Switch - Nufer Medical CERATHERM 600-3 Instruction Manual

17
Instruction Manual CERATHERM 600-3
7.

Operation

Operation of the CERATHERM 600-3 radiant heater has been kept deliberately
straightforward. Use of the unit is largely self-explanatory.
7.1

Master switch

The unit's ON/OFF switch is located on the rear side. This is normally switched on at all
times. The heater head itself is switched on/off with ON/OFF button [7] on the front side. If
this button is used to switch off the unit, it switches to energy-saving standby mode.
If the unit is switched off at the mains switch while it is not in standby
mode (i.e. while heat level 1–4 is active), the mains failure alarm sounds.
The unit cannot differentiate between mains failure and being switched off
Note
in such a case. Pressing alarm confirmation button [6] during a mains
failure alarm silences the buzzer. The alarm LED will continue to flash until
the supply voltage returns or the energy storage unit is empty (min. 15
min).
No. Designation
1 Master switch
22 Fuse holder
14.171.C_GA_Ceratherm_600_3_EN.docx
22
Figure 4
Function
Disconnects the radiant heater from the mains supply
Contains two 3.15 AT microfuses (20 × 5 mm)
Table 3
Nufer Medical AG / 04.07.2014 / DU
1
Seite 17 / 32