Led Lighting; Operation; Changing The Brightness Values - Nufer Medical CERATHERM 600-3 Instruction Manual

21
Instruction Manual CERATHERM 600-3
alarm confirmation button [6]. The alarm is deactivated for the next 15 minutes and the heater
head continues operation at the previous heat output.
The patient must never be left unattended on the reclining surface.
The supportive alarm monitoring function is not activated at safety level.
9.

LED Lighting

The CERATHERM 600-3 is fitted with a modern LED lamp. This cutting-edge light source
has a lower energy consumption and higher service life than other lights. -> Observe the
relevant information in chapter 15!
9.1

Operation

The CERATHERM 600-3's LED lighting has two brightness levels, which can be switched on
and off as follows:
If the LED lighting is switched off:
• Press once: LED switches to bright level (default: 100%).
• Press once: LED switches off again.
• Press once: LED switches to low-light level (default: 20%).
• Press once: LED switches off again.
When the lighting is switched on, the brightness can be switched from 20% to 100% or vice
versa by pressing the relevant lamp button. The light can be switched off by pressing the
previously selected button again.
9.2

Changing the Brightness Values

The brightness values can be set by a specialist in 10% increments from 10–100%.
14.171.C_GA_Ceratherm_600_3_EN.docx Nufer Medical AG / 04.07.2014 / DU Seite 21 / 32