Control Elements On The Front - Nufer Medical CERATHERM 600-3 Instruction Manual

18
Instruction Manual CERATHERM 600-3
7.2

Control Elements on the Front

[2]
[8]
No. Designation
2 Illuminated button: Heat level 1
3 Illuminated button: Heat level 2
4 Illuminated button: Heat level 3
5 Illuminated button: Heat level 4
Illuminated button: Alarm
6
confirmation
7 Illuminated button: ON/OFF
8 Button: LED 20%
9 Button: LED 100%
10 LED: Heat output indicator
11 Warning: Read manual.
Button illumination:
• Buttons 2–7 are illuminated.
• Buttons 8 and 9 are not illuminated.
When the buttons are referred to in the text below, the number will be
Note
given in square brackets [ ].
1
Given output corresponds to default settings.
2
Cannot be any higher than 98% because of the internal hardware monitoring circuit.
14.171.C_GA_Ceratherm_600_3_EN.docx
[3] [4]
1 2
[9]
Function
Sets heat level 1 with 20%
Sets heat level 2 with 50%
Sets heat level 3 with 75%
Sets heat level 4 with 98%
Resets an alarm
On: Level 1 is activated / Off: Heater head on standby
Switches LED lighting on and off, at 20%
Switches LED lighting on and off, at 100%
Displays the heat output via differing blink rates
Read through the manual before commissioning.
[5]
3 4
CERATHERM 600-3
Figure 5
1
2
Table 4
Nufer Medical AG / 04.07.2014 / DU
[10]
[6]
[7]
[11]
Seite 18 / 32