Floor-Stand Dimensions-Units With Ec Fans; Figure 4-17 Floor-Stand And Floor-Planning Dimensions, Downflow, Cw026 - Cw041 With Ec Fans - Emerson CW026 Design Manual

Dimensions
4.6 Floor-stand Dimensions—Units with EC Fans
Figure 4-17 Floor-stand and floor-planning dimensions, downflow, CW026 – CW041 with EC fans
14"
356mm
1"
3/4"
25mm
19mm
31 1/2"
800mm
CENTER FEET
3/4"
19mm
3/4"
19mm
7/8"
23mm
NOTE:
1. This floor stand should be used when EC fans are intended to be lowered under
2. All paneled sides of unit overhang floorstand 1" (25mm).
3. The floor stand used with EC units is not symmetrical and its orientation to the
4. Jack and jack support are shipped loose and are intended to be placed into position
5. Not applicable to 24" high floorstand.
*Leveling feet are provided with 1-1/2" (38mm) adjustment from nominal height "A".
® ™
Liebert CW System Design Manual
Piping access area
46 1/2"
1181mm
CENTER FEET
48"
1219mm
3"
76mm
49 1/2"
1257mm
a raised floor. The standard Liebert CW floor stand can be used "if" the fans are to
remain in their original raised position.
Liebert CW is critical for lowering the EC fans. Unless the floor stand is installed in
the correct position, the blowers will
under each fan and utilized to lower or raise that fan as needed.
no
t lower into the floor stand.
40
See note 4
3/4" 33"
19mm 838mm
5
19 1/4"
489mm
A*
Height,
in. (mm)
A*
24 (610)
30 (762)
36 (914)
42 (1067)
48 (1219)
DPN003212
Rev. 1