Figure 4-20 Floor-Stand And Floor-Planning Dimensions, Downflow, Cw089, Cw106 And Cw114 With Ec Fans - Emerson CW026 Design Manual

Figure 4-20 Floor-stand and floor-planning dimensions, downflow,
CW089, CW106 and CW114 with EC fans
1"
25mm
Piping access
3/4"
19mm
31 1/2"
800mm
CENTER FEET
3/4"
19mm
3/4"
19mm
7/8"
23mm
3"
TYP.
76mm
NOTE:
1. This floor stand should be used when EC fans are intended to be lowered into
2. All paneled sides of unit overhang floorstand 1" (25mm).
3. The floor stand used with EC units is not symmetrical and its orientation to the
4. Jack and jack support are shipped loose and are intended to be placed into position
5. Does not apply to 24" high floorstand.
*Leveling feet are provided with 1-1/2" (38mm) adjustment from nominal height "A".
20 1/4"
514mm
area
59 1/4"
1505mm
118 1/2"
3010mm
SUPPORT FEET CENTERS
120"
3048mm
121 1/2"
3086mm
OVERALL
the floor stand. The standard Liebert CW floor stand can be used "if" the fans are to
remain in their original raised position.
Liebert CW is critical for lowering the EC fans. Unless the floor stand is installed in
the correct position, the blowers will not lower into the floor stand.
under each fan and utilized to lower or raise that fan as needed.
Floor-stand Dimensions—Units with EC Fans
32"
813mm
CENTER FEET
TYP. (2) PLACES
43
See note 4
1" 33"
25mm 838mm
5
19 1/4"
489mm
A*
35"
889mm
OVERALL
Height,
in. (mm)
A*
24 (610)
30 (762)
36 (914)
42 (1067)
48 (1219)
® ™
Liebert CW System Design Manual
DPN003191
Rev. 1