Groove - Cycle93 - Siemens sinumerik 808d Programming And Operating Manual

Cycles
2.5 Turning cycles
"Ok"
2.5.3

Groove - CYCLE93

Programming
CYCLE93(SPD, SPL, WIDG, DIAG, STA1, ANG1, ANG2, RCO1, RCO2, RCI1, RCI2, FAL1,
FAL2, IDEP, DTB, VARI, _VRT)
Parameters
Parameter
SPD
SPL
WIDG
DIAG
STA1
ANG1
ANG2
RCO1
148
3. The "Starting point along facing axis" screen for CYCLE 92 opens.
Parameterise the cycle according to the requirement.
4. Press "Ok". The values and cycle call are transferred into the part program.
A component will be parted off at the position defined in the cycle.
N350 CYCLE92( 40.00000, -50.00000, 6.00000, -1.00000, 0.50000,
,200.00000, 2500.00000, 3, 0.20000, 0.08000, 500.00000, 0, 0, 1, 0, 11000)
Data type
REAL
REAL
REAL
REAL
REAL
REAL
REAL
REAL
Description
Starting point in the transverse axis
Starting point in the longitudinal axis
Groove width (enter without sign)
Groove depth (enter without sign)
Angle between contour and longitudinal axis
Range of values: 0<=STA1<=180 degrees
Flank angle 1: on the side of the groove determined by the
starting point (enter without sign)
Range of values: 0<=ANG1<89.999 degrees
Flank angle 2: on the other side (enter without sign)
Range of values: 0<=ANG2<89.999
Radius/chamfer 1, externally: on the side determined by the
starting point
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0