Siemens sinumerik 808d Programming And Operating Manual page 156
Hide thumbs
Also See for sinumerik 808d:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
Cycles
2.5 Turning cycles
Programming example 2
"Turn."
"Groove"
"OK"
156
1.
From the program editor screen, press "Turn.".
2.
From the vertical softkey, select "Groove".
3.
The "Starting point along facing axis " screen for CYCLE 93 opens.
Parameterise the cycle according to the requirement.
4.
Press "OK" to transfer the values and cycle all into the part program. A
groove is turned at the position defined in the cycle, as shown below:
N230 CYCLE93( 30.00000, -30.50000, 7.00000, 5.00000, 0.00000,
0.00000, 0.00000, 1.00000, 1.00000, ,0.00000, 0.20000, 0.10000,
2.50000, 0.50000, 11, )
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
Turning Part 2: Programming (Siemens instructions)
Advertisement
Table of Contents
