Rigid Tapping - Cycle84 - Siemens sinumerik 808d Programming And Operating Manual

2.4.6

Rigid tapping - CYCLE84

Programming
CYCLE84(RTP, RFP, SDIS, DP, DPR, DTB, SDAC, MPIT, PIT, POSS, SST, SST1, AXN, 0,
0, VARI, DAM, VRT)
Parameters
Parameter
RTP
RFP
SDIS
DP
DPR
DTB
SDAC
MPIT
PIT
POSS
SST
SST1
AXN
PSYS
PSYS
VARI
DAM
VRT
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
Data type Description
REAL Retraction plane (absolute)
REAL Reference plane (absolute)
REAL Safety clearance (enter without sign)
REAL Final drilling depth (absolute)
REAL Final drilling depth relative to the reference plane (enter without
sign)
REAL Dwell time at thread depth (chip breakage)
INT Direction of rotation after end of cycle
Values: 3, 4 or 5 (for M3, M4 or M5)
REAL Thread lead as a thread size (signed):
Range of values 3 (for M3) to 48 (for M48); the sign determines
the direction of rotation in the thread
REAL Thread lead as a value (signed)
Range of values: 0.001 ... 2000.000 mm); the sign determines
the direction of rotation in the thread
REAL Spindle position for oriented spindle stop in the cycle (in
degrees)
REAL Speed for tapping
REAL Speed for retraction
INT Tool axis
Values:
INT Internal parameter; only the default value 0 is possible
INT Internal parameter; only the default value 0 is possible
INT Machining type
Values:
REAL Incremental drilling depth
value range: 0 <= Max. value
REAL Variable retraction value for chip breakage
value range: 0 <= Max. value
1: 1st geometrical axis
2: 2nd geometrical axis
3: 3rd geometrical axis
0: Tapping in one pass
1: Deep-hole tapping with chip breakage
2: Deep-hole tapping with chip removal
Cycles
2.4 Drilling cycles
123