Charging System; Checking; Disassembling And Assembling - wsm BX1800 Workshop Manual

BX1800 · BX2200, WSM

[3] CHARGING SYSTEM

(1) Checking

(2) Disassembling and Assembling

Battery Charging Current
1. After starting the engine, disconnect the battery positive cord (+),
and connect an ammeter and voltmeter. Then switch on all
electrical loads (such as head lights) and measure the charging
current.
NOTE
• Connect an ammeter only after starting the engine.
• When the electrical loads is considerably low or the battery
is fully charged, the specified reading may not be obtained.
Current
Factory spec. Voltage
Dynamo speed
(1) Battery Positive Cord
Continuity across Regulator's Terminals
1. Remove the regulator coupler.
2. Check with a tester whether the regulator is in optimum condition
or not.
Check Table
NOTE
• Type to use a high-resistance tester as far as possible.
• The judgement should be as below table.
indictor moves, otherwise "OFF".
Tester +
terminal
Tester
Blue
− terminal
Blue
Black ON
Blue ON
Cord
colors
Green OFF
Yellow OFF
Red ON
(1) Blue
(2) Black
(3) Blue
Stator
1. Remove the nut (3) and separate the stator comp. (4).
2. Unscrew the screws (1) and remove the stator (2).
(When reassembling)
Tightening torque Nut
(1) Screw
(2) Stator
6-S16
ELECTRICAL SYSTEM
14 to 15 V
14 to 15 V
-1
5200 min
Cord colors
Black Blue Green Yellow
OFF ON ON
ON ON
OFF ON
OFF OFF
OFF OFF OFF
OFF ON ON
(4) Green
(5) Yellow
(6) Red
39.2 to 44.1 N·m
4.0 to 4.5 kgf·m
28.9 to 32.5 ft-lbs
(3) Nut
(4) Stator Comp.
(rpm)
W1018053
"ON" if the
Red
ON ON
ON ON
ON ON
OFF OFF
OFF
ON
W1018232
W1018872
KiSC issued 07, 2006 A