wsm BX1800 Workshop Manual page 259

BX1800 · BX2200, WSM
(B) Hydraulic Cylinder
Clearance between Bushing and Shaft
1. Measure the gear shaft O.D. with an outside micrometer.
2. Measure the bushing I.D. with a cylinder gauge.
3. If the clearance exceeds the allowable limit, replace it.
Factory spec.
Clearance between
bushing and shaft
Allowable limit
Shaft O.D. Factory spec.
Bushing I.D. Factory spec.
Side Plate Thickness
1. Measure the side plate thickness with an outside micrometer.
2. If the thickness is less than the allowable limit, replace it.
Factory spec.
Side plate thickness
Allowable limit
Hydraulic Cylinder Bore
1. Check the cylinder internal surface for scoring or damage.
2. Measure the cylinder I.D. with a cylinder gauge.
3. If the measurement exceeds the allowable limit, replace the
hydraulic cylinder block.
Factory spec.
Cylinder I.D.
Allowable limit
5-S13
HYDRAULIC SYSTEM
0.020 to 0.091 mm
0.0008 to 0.0036 in.
0.12 mm
0.0047 in.
14.970 to 14.980 mm
0.5894 to 0.5898 in.
15.000 to 15.061 mm
0.5906 to 0.5930 in.
W1015972
2.48 to 2.50 mm
0.0976 to 0.0984 in.
2.40 mm
0.0945 in.
W1016194
80.05 to 80.15 mm
3.1516 to 3.1555 in.
80.2 mm
3.1575 in.
W10171300
KiSC issued 07, 2006 A