wsm BX1800 Workshop Manual page 99

BX1800 · BX2200, WSM
(2) Disassembling and Assembling
(A) Cylinder Head and Valves
Alternator, Fan Belt and Muffler
1. Disconnect the radiator hoses and separate the radiator (9) with
recovery tank (7) from engine assembly.
2. Remove the cooling fan (10) and fan pulley.
3. Remove the alternator (6) and fan belt (5).
4. Remove the muffler cover (2) and muffler (3).
5. Remove the starter (4).
6. Disconnect the inlet pipe (1), air cleaner (8) and air cleaner stay
(11).
7. Remove the wire bracket.
8. Remove the engine support LH (12) and RH (13).
(When reassembling)
• Check to see that there are no cracks on the belt surface.
IMPORTANT
• After reassembling the fan belt, be sure to adjust the fan belt
tension.
Air cleaner stay nut
Tightening
torque
Engine support screw
(1) Inlet Pipe
(2) Muffler Cover
(3) Muffler
(4) Starter
(5) Fan Belt
(6) Alternator
(7) Recovery Tank
Cylinder Head Cover
1. Remove the head cover cap nuts.
2. Remove the cylinder head cover.
(When reassembling)
• Check to see if the cylinder head cover gasket is not defective.
Tightening Cylinder head cover cap
torque nut
1-S23
ENGINE
23.5 to 27.5 N·m
D722 2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
48.1 to 55.9 N·m
D905 4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
(8) Air Cleaner
(9) Radiator
(10) Cooling Fan
(11) Air Cleaner Stay
(12) Engine Support LH
(13) Engine Support RH
W10192100
3.9 to 5.9 N·m
D722 0.4 to 0.6 kgf·m
2.9 to 4.3 ft-lbs
6.9 to 8.8 N·m
D905 0.7 to 0.9 kgf·m
5.1 to 6.5 ft-lbs
W1017302
KiSC issued 07, 2006 A