wsm BX1800 Workshop Manual page 298

BX1800 · BX2200, WSM
Charge Lamp (Charging Circuit)
1. Remove the under panel.
2. Disconnect the 6P connector from the regulator after turning the
main switch OFF.
3. Turn the main switch ON and connect a jumper lead from the
wiring harness connector terminal (Black) to the chassis.
4. If the charge lamp does not light, the wiring harness or fuse is
faulty.
(1) Regulator
Engine Oil Pressure Lamp
1. Disconnect the lead from the engine oil pressure switch after
turning the main switch OFF.
2. Turn the main switch ON and connect a jumper lead from the
lead to the chassis.
3. If the engine oil pressure indicator lamp does not light, the wiring
harness is faulty.
(1) Engine Oil Pressure Switch
Engine Oil Pressure Switch Continuity
1. Measure the resistance with an ohmmeter across the switch
terminal and the chassis.
2. If 0 ohm is not indicated in the normal state, the switch is faulty.
3. If infinity is not indicated at pressure over 4.9 kPa (0.5 kgf/cm
psi), the switch is faulty.
In normal state
Resistance
At pressure over
(Switch terminal –
approx. 4.9 kPa
Chassis)
(0.5 kgf/cm
(1) Engine Oil Pressure Switch
6-S19
ELECTRICAL SYSTEM
(a) From Charge Lamp
(a) From Oil Pressure Lamp
0 Ω
Infinity
2
, 7 psi)
KiSC issued 07, 2006 A
W1020208
W1025954
2
, 7
W1026084