Table of Contents
Advertisement
decoder module) to transfer the START/AUX function to the receiver. To transfer I-Chip information
to the receiver, JP6 must be inserted (not required if programmed directly on the decoder
module – Section E).
6.
Program Transmitter Output Power
Change transmitter output power simply by moving the black arrow on the LCD screen to the PWR
location via NEXT and PREVIOUS button, then press ↑ & ↓ arrows to change the output power.
"-23" value will give you the shortest transmitting range but longest battery life while "+12" value will
give you the longest transmitting range but shortest battery life. We recommend that for indoor
applications, the transmitter output power should be set from "-5" to "+3" value. For outdoor
applications, we recommend that you set the transmitter output power from "+6" to "+10" value.
7.
Program Transmitter On Time / Transmitting Time
Not applicable for FCC systems.
8.
Program System RF Channel
Change the system channel simply by moving the black arrow on the LCD screen to the CH
location via NEXT and PREVIOUS button, then either press the ↑ & ↓ arrows or the number buttons
directly to change system channel.
9.
Program Transmitter Push Button Functions
Program transmitter push button functions (transmitter toggle and select functions) simply by
moving the black arrow on the LCD screen to the FUNC location via NEXT and PREVIOUS button,
then either press the ↑ & ↓ arrows or the number buttons directly to set transmitter push button
functions. The transmitter push button function tables on the following pages tell you which number
value correspond to which push button function.
Flex I-Chip Remote Crane Controls
August 2010
13 of 28
Advertisement
Table of Contents
